EnGenius ENH220EXT Uživatelský manuál stáhnout pdf (Strana 14)

1. Connect one end of the Ethernet cable into the main

LANport(PoE)oftheAccessPointandtheotherendto

the AP Ethernet port on the PoE injector.

2. Connect the Power Adapter to the DC-IN port of the

PoE injector and plug the other end into an electrical

outlet.

3. Connect the second Ethernet cable into the LAN port of

the PoE injector and the other end to the Ethernet port

on the computer.

4. Screw on the provided antennas to the device. Once

both connections are secure, verify the following:

a) Ensure that the POWERlightison(itwillbegreen).

b) Ensure that the WLAN light is on.

  c)EnsurethattheLAN(Computer/ENH220EXT

 Connection)lightison(itwillbegreen).

d) Once all three lights are on, proceed to setup the

Access Point using the computer.

Thefollowingdiagramdepictsthehardwareconguration:

Note: The Access Point supports both IEEE 802.3at PoE

(Power over Ethernet) or the included power injector.

You may use either one as the power source. Do NOT

use both at the same time.

Hardware Installation

Ethernet

Power

Outlet

PoE Injector/

PoE Swtich

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 66 67

Žádné komentáře

EnGenius ENH220EXT Uživatelský manuál Strana 14